CTX 1300 Forum banner
1 - 5 of 5 Posts

· Premium Member
Joined
·
1,160 Posts
Discussion Starter · #1 ·
Just got the technical manual from Ron :ty:.

Still looking for the pages to set the gap for the points in the distributor. :tongue:

Anything else you didn't find in there?
 

· Registered
Joined
·
446 Posts
(refusing to bite an obvious bait)

Nope, it appears pretty comprehensive.
 
  • Like
Reactions: bob

· Registered
Joined
·
105 Posts
Just got the technical manual from Ron :ty:.

Still looking for the pages to set the gap for the points in the distributor. :tongue:

Anything else you didn't find in there?
What about the jetting for the carbs......:smileygarden_de_ban
 

· Registered
Joined
·
2,003 Posts
What about the jetting for the carbs......:smileygarden_de_ban
Everyone knows you don't need to re-jet, just shim needle to the 3rd notch. And you can get get 'em(shims) at advanced auto cheaper than the dealer. Section F, p. 36 example c. Don't listen to the dealer about the re-jetting upping hp.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top